2000W with charge inverter can be turned on normally but does not work with 500 or 600 watt load

Model

BP series with charge inverter 2000W 48VDC 220VAC

Description

1. It can be turned on normally, but when it is loaded with a load of 500 or 600 watts, it cannot work.

2. After sending it back for power-on test, there is a failure to start the machine, and it cannot be started.

Analysis of the possibility of the cause

Check the inverter and confirm that the rear driver board is damaged.

Solutions and steps

Replace the rear driver board.

• Related Articles

• Portable power supply turned on inverter damage

  Model BPlus Series Pure Sine Wave Inverter 36VDC/1000W/220VAC Description B36P1000-2 which integrated into the portable power supply will be damaged when it is turned on. Analysis of the possibility of the cause 1. When checking the usage status of ...

• 3000W inverter fails after the three-circuit load is fully opened

  Model BP series pure sine wave inverter 3000W 24VDC 220VAC Description 1. Input DC 23V, Output AC221V, with 3.8A output current of two way load. 2. Two of the three way loads can run normally. After the three-circuit load is fully opened, it will ...

• 6000W inverter stops outputting after running with load

  Model BP series pure sine wave inverter 12VDC 220VAC 6000W Description The device fails and stops outputting in seconds after running with load. Specific Performance: Inverter's front end has been connected with 5 batteries (aged batteries after ...

• BP2000W bypass inverter connected to the mains no output but the inverter state work normally

  Model BP series with bypass inverter 2000W 24VDC 220VAC Description In the inverter state, it is normal. In the mains state, it does not work and has no output. Analysis of the possibility of the cause The fuse of the mains input port is damaged, ...

• The external small power fan causes the 3000 watt inverter to burn out due to high temperature

  Model BPlus series pure sine wave inverter 3000W 48VDC 110VAC Description Because it was a bare machine, the customer configured the fan himself, fan was low power and the air duct was blocked, the temperature was too high in a short period of time ...