300W Inverter direct alarm and fault light on at power on
Model
BP series pure sine wave inverter 300W 48VDC 220VAC
Description
Alarm directly when starting, the fault light is on, and the buzzer sounds.
Analysis of the possibility of the cause
Checking the circuit board, it was found that the problem was caused by the rectifier bridge in the rear, and the fast recovery diode 1660CTA of the half bridge was damaged.
Solutions and steps
Replace the fast recovery diode.
Related Articles
4000 watt inverter working light and fault light on but no output after power on
Model BP series pure sine wave inverter 4000W 24VDC 220VAC Description No output, working light on, fault light on, buzzer sounding after power on. Analysis of the possibility of the cause Open the cover and check the internal components, 2 MOS tubes ...
BP 300W inverter fault light does not light up after power on but no output voltage
Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...
The external small power fan causes the 3000 watt inverter to burn out due to high temperature
Model BPlus series pure sine wave inverter 3000W 48VDC 110VAC Description Because it was a bare machine, the customer configured the fan himself, fan was low power and the air duct was blocked, the temperature was too high in a short period of time ...
6000W inverter buzzer buzzes without output after startup
Model BP series pure sine wave inverter 6000W 12VDC 220VAC Description After startup, there is no output, the fault light is on, and the buzzer buzzes. Analysis of the possibility of the cause After opening the cover for inspection, it was determined ...
Continuous alarm on 4,000 watt pure sine inverter
Model BP Series Pure Sine Wave Inverter 24VDC 120VAC 4000W Description Turned on the inverter and found the alarm going on continuously. the output seems to be normal and there are no alarm lights or codes displayed so nothing showing any kind of an ...