The BP1000W inverter working indicator is normal after starting but no output
Model
BP Series Pure Sine Wave Inverter 36VDC 220VAC 1000W
Description
1. The working indicator is normal after starting, but there is no output.
2. The device is used in cars.
Analysis of the possibility of the cause
1. The output inductor pin is broken by internal inspection , resulting in no voltage at the output interface.
2. Because the device is installed in a car, the pin breaks due to long-term bumps.
Solutions and steps
1. Pay more attention to the factory inspection that whether the fixing glue of this part is enough and whether it is firmly fixed.
2. When installing on a car, the customer needs to add a certain amount of buffer protection.
Related Articles
1000W inverter stop working suddenly and can't restart
Model BP Series Pure Sine Wave Inverter 12VDC 220VAC 1000W Description The inverter suddenly stop working under normal power-on conditions, and then can’t restart. Analysis of the possibility of the cause 1. Check the main board and find that the ...
600W inverter beeps continuously but input and output voltages are normal
Model BP Series Pure Sine Wave Inverter 12VDC 220VAC 600W Description 1. After starting up, the buzzer will beep for a long time, the output end of the bulb can be lighted normally, the working indicator is always on, and the fault indicator is not ...
2500W inverter's fualt indicator flashes without output voltage
Model BP series pure sine wave inverter 2500W 12VDC 220VAC Description After startup, the work indicator is on, and the fault indicator flashes intermittently and the buzzer sounds, without output voltage. Analysis of the possibility of the cause ...
4000 watt inverter working light and fault light on but no output after power on
Model BP series pure sine wave inverter 4000W 24VDC 220VAC Description No output, working light on, fault light on, buzzer sounding after power on. Analysis of the possibility of the cause Open the cover and check the internal components, 2 MOS tubes ...
BP 300W inverter fault light does not light up after power on but no output voltage
Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...