BP 300W inverter fault light does not light up after power on but no output voltage
Model
BP series pure sine wave inverter 300W 24VDC 220VAC
Description
Turn on normally, the fault light is off, but there is no output voltage.
Analysis of the possibility of the cause
After checking and replacing, it is determined that the rear driver board is damaged.
Solutions and steps
Replace the rear driver board.
Related Articles
4000 watt inverter working light and fault light on but no output after power on
Model BP series pure sine wave inverter 4000W 24VDC 220VAC Description No output, working light on, fault light on, buzzer sounding after power on. Analysis of the possibility of the cause Open the cover and check the internal components, 2 MOS tubes ...
300W Inverter direct alarm and fault light on at power on
Model BP series pure sine wave inverter 300W 48VDC 220VAC Description Alarm directly when starting, the fault light is on, and the buzzer sounds. Analysis of the possibility of the cause Checking the circuit board, it was found that the problem was ...
2500W inverter's fualt indicator flashes without output voltage
Model BP series pure sine wave inverter 2500W 12VDC 220VAC Description After startup, the work indicator is on, and the fault indicator flashes intermittently and the buzzer sounds, without output voltage. Analysis of the possibility of the cause ...
No output after running 2-3 months of BP 2000 watt power inverter
Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description No output after using for 2-3 months, red and blue light are on at same time. Analysis of the possibility of the cause 1.The ambient temperature and humidity of the inverter is ...
6000W inverter buzzer buzzes without output after startup
Model BP series pure sine wave inverter 6000W 12VDC 220VAC Description After startup, there is no output, the fault light is on, and the buzzer buzzes. Analysis of the possibility of the cause After opening the cover for inspection, it was determined ...