BP2000W bypass inverter connected to the mains no output but the inverter state work normally
Model
BP series with bypass inverter 2000W 24VDC 220VAC
Description
In the inverter state, it is normal. In the mains state, it does not work and has no output.
Analysis of the possibility of the cause
The fuse of the mains input port is damaged, which should be caused by overload operation in the mains state.
Solutions and steps
Replace the fuse.
Related Articles
No output voltage after the BP 600w inverter is turned on and the fault light flashes
Model BP series with bypass inverter 600W 12VDC 220VAC Description Can not be turned on normally, the fault light flashes after turning on, no output voltage. Analysis of the possibility of the cause 1. Check the internal circuit, the bus voltage is ...
BP 300W inverter fault light does not light up after power on but no output voltage
Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...
The BP 2500W inverter did not output and had smell of burnt
Model BP series pure sine wave inverter 2500W 24VDC 220VAC Description The inverter did not output and had smell of burnt. After opening, DC input part MOS tube and fuse exploded, and DC input control board was damaged. Analysis of the possibility of ...
The battery was connected oppositely, leading to blowout of fuse and damage of AC output part MOS tube.
Model BP series Description The battery was connected oppositely, leading to blowout of fuse and damage of AC output part MOS tube. Solutions and steps 1,According to the customer's response, after replacing the lithium battery, the front ...
The 2000W inverter output short circuit no response to power on
Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description The customer describes the output short circuit, the inverter has no response when it is turned on, and there is no output voltage. Analysis of the possibility of the cause 1. ...