BP600W inverter has no voltage output after power on but the fault light does not light up
Model
BP series pure sine wave inverter 600W 12VDC 220VAC
Description
After power on, the fault light does not light up and there is no output voltage.
Analysis of the possibility of the cause
1. Check the internal circuit, the rear part is damaged.
2. In addition to the damage of the rear MOSfet and the rear driver board, the corresponding drive resistor and diode are damaged this time.
Solutions and steps
Replace the above damaged components.
Related Articles
No output voltage after the BP 600w inverter is turned on and the fault light flashes
Model BP series with bypass inverter 600W 12VDC 220VAC Description Can not be turned on normally, the fault light flashes after turning on, no output voltage. Analysis of the possibility of the cause 1. Check the internal circuit, the bus voltage is ...BP 300W inverter fault light does not light up after power on but no output voltage
Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...4000 watt inverter working light and fault light on but no output after power on
Model BP series pure sine wave inverter 4000W 24VDC 220VAC Description No output, working light on, fault light on, buzzer sounding after power on. Analysis of the possibility of the cause Open the cover and check the internal components, 2 MOS tubes ...The fault light is on and the buzzer sounds after the 300W inverter is turned on
Model BP series pure sine wave inverter 300W 24VDC 220VAC Description After power on, the fault light is on, the buzzer sounds, and there is no output voltage. Analysis of the possibility of the cause 1. Check the internal components, the front and ...BP3000W inverter on after the fault light flashes buzzer sound
Model BP series pure sine wave inverter 3000W 12VDC 110VAC Description After power on, the fault light flashedand buzzer sounded, and it could not work normally. Analysis of the possibility of the cause 1. Check the internal circuit to confirm that ...