BPlus-3000W inverter will restart when it loaded with 1.6KW

• Related Articles

• The BPlus series 2000W inverter startup normal and not alarm but has no output voltage

  Model BPlus Series Pure Sine Wave Inverter 48VDC 110VAC 2000W Description The startup is normal, the inverter does not alarm, but there is no output voltage. Analysis of the possibility of the cause The test of the auxiliary power supply part is ...

• Inverter damaged AC output part mosfet caused by overload

  Model BPlus Series pure sine wave inverter Description The inverter still ran even after short circuit because of a full load in AC output, which damaged AC output part MOS tube. Fault Causes The inverter still overloaded after short ...

• After starting up engine in high-speed rail, inverter will restart

  Model BP Series Pure Sine Wave Inverter 300W 110VDC 220VAC Description 1. When used in trains, the inverter can be started up normally after opening its front-end circuit breaker; 2. After starting up internal combustion engine in train, inverter ...

• How will the inverter be affected if the input voltage is too high？

  Model BP series/BPlus series/Helios Description If the input voltage of battery exceeded defult value, capacitance will bulge/explode and further damage DC input part MOS tube. Analysis of the possibility of the cause The input voltage of DC battery ...

• 1000W inverter stop working suddenly and can't restart

  Model BP Series Pure Sine Wave Inverter 12VDC 220VAC 1000W Description The inverter suddenly stop working under normal power-on conditions, and then can’t restart. Analysis of the possibility of the cause 1. Check the main board and find that the ...