DC or Battery input reverse solution for pure sine wave inverter B24P600-2

Model

BP Series Pure Sine Wave Inverter 24VDC 220VAC 3000W

Description

When inverter running , the LED lights off , and AC output no power.

Analysis of the possibility of the cause
DC or Battery input reverse.

Solutions and steps

1. Remove all wire from Pure sine wave inverter, include battery and AC output.

2.Clear surface dust.

3.Uninstall screws from Front and rear panels.

4.Open the top cover.

5.Dial out the fuse.

6.Check and replace bad fuses.

7.Close and complete.

• Related Articles

• Display not same actual situation of BPlus 2000W inverter

  Model BPlus series pure sine wave inverter 2000W 12VDC 120VAC Description 1. DC input voltage 11.3V, input current 0.2167A. But the data shown on inverter display is inconsistent with the actual situation. As shown in figure 1. 2. Theoretically, the ...

• Battery connected oppositely reverse, fuse and Mosfet damage of the inverter

  Model BP series pure sine wave inverter Description The battery was connected oppositely, leading to blowout of fuse and damage of AC output part MOS tube.  Analysis of the possibility of the cause The positive and negative pole of DC battery was ...

• Inverter is no output voltage after the customer has used it for a period of time

  Model BP Series Pure Sine Wave Inverter 36VDC 220VAC 1000W Description There is no output voltage after the customer has used it for a period of time. Analysis of the possibility of the cause 1. The disassembly test found that there is no auxiliary ...

• Why sometimes inverters can't support other kinds of batteries?

  Model BP2000-S pure sine wave inverter   Description The inverter can work normally when using AGM battery. After replacing it with a lithium battery, the situation shown in the figure appears, the front-stage MOSFET bursts.   Solutions and steps ...

• 1000W inverter cannot running when battery voltage between 41V - 42V

  Model BP Series Pure Sine Wave Inverter 1000W 220V Description 1. Wiring mode of the faulty machine: the rocker switch on the switch board is in a short-circuit state, and daily power supply started by switching battery input. 2. Failure phenomenon ...