Inverter no output of BP Series 3000W

Inverter no output of BP Series 3000W pure sine wave inverter

Model

BP series pure sine wave inverter 3000W 48VDC 220VAC


Description

Inverter no output


Analysis of the possibility of the cause
It's probably the battery voltage is too low.


Solutions and steps

Improve the power startup voltage.




PS: The boot voltage should be 1V higher than our norminal voltage, which means for 48V machine, the boot voltahe should be 49V or higher.

    • Related Articles

    • No output of BP Series pure sine wave inverter 12VDC 220VAC 1000W

      Model BP series pure sine wave inverter 1000W 12VDC 220VAC Description Red and blue lights come on after startup. The machine has no output and the battery voltage is 12.7V. Analysis of the possibility of the cause The battery is short of voltage, ...

    • Power inverter AC output part Mosfet/IGBT module exploded

      Model BP series pure sine wave inverter Description AC output part MOS tube/ IGBT module exploded. AC output part driver board, corresponding resistances and PCB board were damaged. Fault Causes AC output was connected with grid. Solutions and steps ...

    • Inverter damaged AC output part mosfet caused by overload

      Model BPlus Series pure sine wave inverter Description The inverter still ran even after short circuit because of a full load in AC output, which damaged AC output part MOS tube. Fault Causes The inverter still overloaded after short ...

    • No output after running 2-3 months of BP 2000 watt power inverter

      Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description No output after using for 2-3 months, red and blue light are on at same time.  Analysis of the possibility of the cause 1.The ambient temperature and humidity of the inverter is ...

    • Portable power supply turned on inverter damage

      Model BPlus Series Pure Sine Wave Inverter 36VDC/1000W/220VAC Description B36P1000-2 which integrated into the portable power supply will be damaged when it is turned on. Analysis of the possibility of the cause 1. When checking the usage status of ...