No output of BP Series pure sine wave inverter 12VDC 220VAC 1000W

No output of BP Series pure sine wave inverter 12VDC 220VAC 1000W

Model

BP series pure sine wave inverter 1000W 12VDC 220VAC


Description

Red and blue lights come on after startup. The machine has no output and the battery voltage is 12.7V.


Analysis of the possibility of the cause

The battery is short of voltage, thus the machine cannot start up.


Solutions and steps:

Increase input battery voltage.


    • Related Articles

    • Inverter no output of BP Series 3000W pure sine wave inverter

      Model BP series pure sine wave inverter 3000W 48VDC 220VAC Description Inverter no output Analysis of the possibility of the cause It's probably the battery voltage is too low. Solutions and steps Improve the power startup voltage. PS: The boot ...

    • Power inverter AC output part Mosfet/IGBT module exploded

      Model BP series pure sine wave inverter Description AC output part MOS tube/ IGBT module exploded. AC output part driver board, corresponding resistances and PCB board were damaged. Fault Causes AC output was connected with grid. Solutions and steps ...

    • Inverter damaged AC output part mosfet caused by overload

      Model BPlus Series pure sine wave inverter Description The inverter still ran even after short circuit because of a full load in AC output, which damaged AC output part MOS tube. Fault Causes The inverter still overloaded after short ...

    • Output voltage is unsteady of BPlus Series 300W inverter

      Model BPlus series pure sine wave inverter  300W 12VDC 220VAC Description The inverter can be started up but its output voltage is unsteady. Analysis of the possibility of the cause R18 resistance in bus voltage has been damaged, the transient ...

    • No output after running 2-3 months of BP 2000 watt power inverter

      Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description No output after using for 2-3 months, red and blue light are on at same time.  Analysis of the possibility of the cause 1.The ambient temperature and humidity of the inverter is ...