The BP 2500W inverter did not output and had smell of burnt

Model

BP series pure sine wave inverter 2500W 24VDC 220VAC

Description

The inverter did not output and had smell of burnt. After opening, DC input part MOS tube and fuse exploded, and DC input control board was damaged.

Analysis of the possibility of the cause

Mostly the battery was connected oppositely. 

Solutions and steps

Cannot be repaired.

 

• Related Articles

• BP 300W inverter fault light does not light up after power on but no output voltage

  Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...

• No output voltage after the BP 600w inverter is turned on and the fault light flashes

  Model BP series with bypass inverter 600W 12VDC 220VAC Description Can not be turned on normally, the fault light flashes after turning on, no output voltage. Analysis of the possibility of the cause 1. Check the internal circuit, the bus voltage is ...

• No output after running 2-3 months of BP 2000 watt power inverter

  Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description No output after using for 2-3 months, red and blue light are on at same time.  Analysis of the possibility of the cause 1.The ambient temperature and humidity of the inverter is ...

• The 2000W inverter output short circuit no response to power on

  Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description The customer describes the output short circuit, the inverter has no response when it is turned on, and there is no output voltage. Analysis of the possibility of the cause 1. ...

• The BP1000W inverter working indicator is normal after starting but no output

  Model BP Series Pure Sine Wave Inverter 36VDC 220VAC 1000W Description 1. The working indicator is normal after starting, but there is no output. 2. The device is used in cars. Analysis of the possibility of the cause 1. The output inductor pin is ...