The internal circuit board rusts of BP Series 12VDC 220VAC 600W inverter

Model

BP series pure sine wave inverter  600W 12VDC 220VAC

Description

Cannot start the inverter up. Part components of the internal circuit board rusts.

Analysis of the possibility of the cause

Water has got into the inverter or it was used in extremely humid surroundings. Both front-end and back-end MOS tubes have been damaged.

Solutions and steps:

Deliver it back to factory to take a complete inspection.

• Related Articles

• The 2000W inverter output short circuit no response to power on

  Model BP series pure sine wave inverter 2000W 12VDC 220VAC Description The customer describes the output short circuit, the inverter has no response when it is turned on, and there is no output voltage. Analysis of the possibility of the cause 1. ...

• No output voltage after the BP 600w inverter is turned on and the fault light flashes

  Model BP series with bypass inverter 600W 12VDC 220VAC Description Can not be turned on normally, the fault light flashes after turning on, no output voltage. Analysis of the possibility of the cause 1. Check the internal circuit, the bus voltage is ...

• BP3000W inverter on after the fault light flashes buzzer sound

  Model BP series pure sine wave inverter 3000W 12VDC 110VAC Description After power on, the fault light flashedand buzzer sounded, and it could not work normally. Analysis of the possibility of the cause 1. Check the internal circuit to confirm that ...

• 3000W inverter fails after the three-circuit load is fully opened

  Model BP series pure sine wave inverter 3000W 24VDC 220VAC Description 1. Input DC 23V, Output AC221V, with 3.8A output current of two way load. 2. Two of the three way loads can run normally. After the three-circuit load is fully opened, it will ...

• BP 300W inverter fault light does not light up after power on but no output voltage

  Model BP series pure sine wave inverter 300W 24VDC 220VAC Description Turn on normally, the fault light is off, but there is no output voltage. Analysis of the possibility of the cause After checking and replacing, it is determined that the rear ...